DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
V003. 25.06.2002
B-38
Th
ir
d r
ack
46
32
33
34
35
36
37
38
39
40
41
42
43
44
45
Second rack
30
16
17
18
19
20
21
22
23
24
25
26
27
28
29
FI
RST C
A
BI
NET
Fi
rst ra
ck
14
00
01
02
03
04
05
06
07
08
09
10
11
12
13
UTIL200 cards
EX200 or EVM200 cards
CPU200 card (no slot number)
CC Enable card (no slot number)
After the visual test and the necessary arrangements are completed, it would be useful to
check the system in general simply.
Choosing extensions from various racks randomly and then arranging phone calls among
them by establishing connections would be sufficient to test the fundamental structure of the
system. At this point, it becomes a necessity to have a good command of the numbering plan
of the system. Therefore, it would be wise to run the ADMIN200 program and review the
numbering plan through the “Configuration” window.
Once the ADMIN200 program runs and the “Configuration” window opens, numbers of the
lines on a card can be viewed as long as the mouse cursor is placed onto the related card
and the left mouse button is kept pressed.
When the system test is over, shut down the system, make the line connections over the
main distribution pane, complete the entire accessory connections and then put the system
on line again for use.
Afterwards, the related programming must be done preferably through the ADMIN200
program.
!
!!
!"
"
"
"
WARNING
All the programmed parameters must be saved in the non-
volatile memory of the system and then they should be backed-
up to a PC through ADMIN200.
