DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
DS200 Installation Guide
V003. 25.06.2002
B-33
II. PUTTING THE SYSTEM ON LINE
After all the cards have been installed, the system is ready to be powered.
The methods for properly powering the system have been listed below for different system
configurations:
II.1. SINGLE-RACK, WALL-TYPE SYSTEM
1) Make sure the entire cables in the rack have been connected properly.
2) Check if the mains and battery switches on the SPS200 module are off.
3) Connect the mains cord to the SPS200 module and then plug it into an outlet of the
premise that has been properly grounded.
4) Connect the batteries (if battery connection is to be made) to the battery connectors
of the SPS200 module.
5) Turn on the mains switch on the SPS200 module.
6) Turn on the battery switch on the SPS200 module.
II.2. TWO-RACK WALL-TYPE SYSTEM
1) Make sure the entire inner-rack and inter-rack connections have been made
properly.
2) Check if the mains and battery switches on the entire SPS200 modules are off.
3) Connect the mains cords to the SPS200 modules and then plug them into an outlet of
the premise that has been properly grounded.
4) Connect the batteries (if battery connection is to be made) to the battery connectors
of the first SPS200 module (Note that no connection shall be made to the second
SPS200 module.)
5) Turn on the mains switches on the SPS200 modules.
6) Turn on the battery switch that is on the SPS200 module to which the batteries have
been connected.
II.3. CABINET-TYPE SYSTEM
1) Make sure the entire inner-rack and inter-rack connections have been made
properly.
2) Check, if the primary mains switch, which is on the control panel of the cabinet, is off.
3) Check, if the primary battery switch, which is on the control panel of the cabinet, is
off.
4) Check if the mains and battery switches on the entire SPS200 modules are off.
