Kärcher HDS 5/11 U, Руководство пользователя

Страница: 17 / 232

– 4
 DANGER
Risk of injury! Switch the appliance off prior to replacing
nozzle and activate hand spray gun until device is pres-
sureless.
 Secure the trigger gun. To do so, push the safety
catch towards the front.
 Replacing the nozzle.
Illustration
1 Operating with cold water
2 Operating with hot water
 Set appliance switch to desired operating mode.
The device starts briefly and turns off, as soon as the
working pressure is reached.
 Release the trigger gun. To do so, push the safety
catch towards the back.
When activating the hand spray gun the device switch-
es back on.
Note: If no water comes out of the high pressure nozzle,
vent pump.
Vent pump:
 With open hand spray gun turn device on and off
multiple times with the device switch.
Note: By dismantling the spray lance from the hand
spray gun, the venting process is accelerated.
 Release the pulling lever; the device will switch off.
Secure the trigger gun. To do so, push the safety
catch towards the front.
 Release the trigger gun. To do so, push the safety
catch towards the back.
Release the pulling lever again; the device will
switch on again.
 Close the hand spray gun.
 Secure the trigger gun. To do so, push the safety
catch towards the front.
 Turn the casing of the nozzle till the desired symbol
matches the marking.
– For considerate treatment of the environment use
detergent economically.
– The detergent must be suitable for the surface to
be cleaned.
Illustration
 Take out detergent suck hose.
 Turn filter on the detergent suction hose in order to
dispense the detergent.
 Suspend end of suction hose in a container filled
with detergent.
 Set nozzle to "CHEM".
 Set the detergent concentration according to the
surface to be cleaned.
Note: To prevent damage due to too much pressure, al-
ways position high pressure ray first from a greater dis-
tance towards object to be cleaned.
– Loosen the dirt:
 Spray detergent economically and let it work for
1...5 minutes but do not let it dry up.
– Remove the dirt:
 Spray off loosened dirt with the high pressure jet.
Removal of light contaminations and clear rinse, i.e.:
Gardening tools, terrace, tools, etc.
 Set the appliance switch to "1".
 DANGER
Scalding danger!
 Set the appliance switch to "2".
 Completely close the filter at the detergent suction
hose (-).
 Set the appliance switch to "1".
 Open the hand spray gun and rinse the appliance
for at least 1 minute.
 DANGER
Danger of scalding from hot water! After operation with
hot water, the device must be operated with opened
handgun with cold water for at least two minutes.
 Shut off water supply.
 Open the hand spray gun.

Switch on the pump with the power switch and al-
low to run for about 5-10 seconds.
 Close the hand spray gun.

Set the appliance switch to "0/OFF“.
 Pull main plug out of socket with dry hands only.
 Remove water connection.

Activate hand spray gun until device is pressure
less.
 Secure the trigger gun. To do so, push the safety
catch towards the front.
Replace the nozzle
Operating modes
0/OFF = Off
Turning on the Appliance
Interrupting operation
Select spray type
High pressure circular spray (0°) for
specially stubborn dirt
Flat low pressure spray (CHEM) for op-
erating using detergents or cleaning at
low pressure.
High pressure flat spray (25°) for large
dirt areas
Operation with detergent
Cleaning
Recommended cleaning method
Operating with cold water
Operating with hot water
After operation with detergent
Turn off the appliance
17 EN