◆
1.Attention on use
※
Please confirm without fail before use.
For the hot-air generator is used without malfunctioning
Important matters that demand special attention that became the cause of malfunction that occurred in the
past is entered. Please inquire with the use method of your company.
●
Please attach the demi-filter or CR-filter without fail to the suction side of the hot-air
generator.
●
Please clean always the filter that is used or wire net of the hot-air generator inlet. (Standard
equipment) Heater inside is overheated by the clogging of the filter and the hot-air generator
may can not operate.
●
Hot-air generator malfunctions when these adhered to the controller inside of the hot-air
generator in the case that dust, mine dust, floating objects that pass electricity of carbon
fiber, oil, lampblack, oil mist, moisture, and vapor is included to the atmosphere of the setting
place of the hot-air generator.
●
Leakage of the hot-air is occurred without fail on the characteristic of the flexible hose in the
case of the piping by the flexible hose to the outlet and inlet of hot-air generator. Electron
devices inside the operation panel are damaged by the hot-air of the high temp. that leaked
flows backward to the hot-air generator inside. So, please execute the glass tape for the air
leakage prevention that was enclosed to the outlet and inlet.
●
Input terminal A1-A10 and output terminal B8-B10 is malfunctioned by the voltage is
applied. And, output terminal B1-B7 is malfunctioned by the voltage more than the rating is
applied.
●
Please do not unite or wire that was adjoined the wiring of the service terminal with the
power supply line, high tone wave line. Electron devices of the inside are damaged by noise.
●
Please do not stopped the hot-air generator with the electromagnet contact device that was
established to the first side of the hot-air generator. Electron devices of the inside are
damaged by serge voltage.
●
The thunder serge that occurred by falling of a thunderbolt becomes a cause to the wrong
action, damage, and fire accident of the hot-air generator. Please attach the arrester without
fail and please perform the falling of a thunderbolt measure in the case that the hot-air
generator is used in the place where receives the influence of falling of a thunderbolt.
●
Please use the commercial power supply (50/60Hz) that has the sine wave-like to the power
supply of the hot-air generator. Please do not use the power supply that has the distortion
wave including a high tone wave from the frequency transformation device absolutely.
Electron devices of the inside are damaged by high tone wave and noise.
●
Please do not bend and do not change the height the sensor for the temp. measuring that is
equipped to the outlet of the hot-air generator. Short
circuit occurs if the sensor contacts to
the heater.
－１－
