Kannad AF INTEGRA, Руководство по установке

Страница: 31 / 60

INITIAL INSTALLATION MANUAL
AF INTEGRA / AF-H INTEGRA
PAGE: 27
JUN 01/2011
(5) RC600 NVG
The RC600 NVG RCP is designed to be installed in a standard rack of a
military helicopter cockpit. As compliant with NF L 65-211 standard, no
drilling is necessary to install this RCP.The precise location of RC600 is to
be determined according to aircraft manufacturer instruction.
A female 22-pin socket, reference D38999/26JC35SA, must be used as
mating connector to connect the bundle to the RCP connector.
Connection with DIN-12 connector or Programming dongle
Refer to Figure 44: RC600 Wiring diagram, page 52
Fabricate a 4-wire bundle (AWG 24, shielded preferred) long enough to
reach between the ELT installation location and the cockpit panel RCP
location. Slide heat-shrinkable sleeves on both sides of each wire.
On the ELT side:
- Solder the wires to the DIN-12 connector (or programming dongle) to be
connected to the ELT or to the DIN-12 male connector of RCP bundle if
a Programming Dongle ASSY is used (
Refer to Figure 17: Programming
Dongle ASSY ).
On the RCP side:
- Solder the wires to the female 22-pin socket according to wiring
diagram.
- Connect Ouside Lamp, Horn, Lamp test and Backlight.
- If an optional outside buzzer is connected:
• Mount and install the buzzer: Refer to Section 7. Outside Buzzer
Installation, page 28
• Connect the buzzer: Refer to Figure 44: RC600 Wiring diagram, page
52 .
Put heat-shrinkable sleeves to protect the pins.
- Connect the female 22-pin socket to the male 22-pin plug of RC600.