Kannad AF INTEGRA, Руководство по установке

Страница: 22 / 60

INITIAL INSTALLATION MANUAL
AF INTEGRA / AF-H INTEGRA
PAGE: 18
JUN 01/2011
6. RCP installation
A. RCP Installation Recommendations
The RCP shall be installed in the cockpit. The RCP shall be readily accessible
from the pilot’s normal seated position.
B. RCP Installation Procedure
The RCP must be connected to the ELT via a DIN-12 connector (P/N
S1820514-03) or a Programming Dongle (
Refer to Section 12. Compatibility list
for INTEGRA ELTs System, page 53 ) on the ELT side and the relevant mating
connector of the RCP on the RCP side (except for RC100 and RC102, wires
directly connected to the RCP without connectors).
Figure 15: Example of connection ELT to RCP
NOTE 1: in order to easily remove the programming dongle, when the RCP is
connected to the ELT via a Programming Dongle (P/N S1820514-01), it is
recommended to fit its cable with a stopping connector as close as possible to
it (see figure below).
Figure 16: Bundle with stopping connector
NOTE 2: The mounting of a stopping connector may be skipped by using our
pre-wired Programming Dongle ASSY (P/N S1820514-06). This dongle is fitted
with the Programming Dongle (S1820514-01) on the ELT side and a female
DIN-12 connector on the RCP side. In this case, a RCP bundle must be
fabricated using a male DIN-12 connector (reference P/N S1820514-03 or
BINDER 680-1-09-0329-00-12) and the relevant mating connector of the RCP.
Figure 17: Programming Dongle ASSY