Kannad AF INTEGRA, Руководство по установке, Страница: 25 / 60

INITIAL INSTALLATION MANUAL
AF INTEGRA / AF-H INTEGRA
PAGE: 21
JUN 01/2011
(2) RC102
RC102 RCP is supplied as a kit ( Refer to Figure 19: RC102 mounting
diagram, page 23 ). 2 types of front plates may be installed. Choose the
appropriate front plate according to the aircraft’s instrument panel. The kit
also includes 2 LEDs. The white LED is a NVG LED (Night Vision Goggles)
only used for military aircraft, the red LED is a standard LED.
CAUTION: use NVG LED only for military aircraft equipped for night
vision googles. Never install this LED in RCP for standard aircraft.
Connection of RC102 requires a 2-wire bundle. A pin-to-pin wiring has to
be provided by the installer with AWG24 wires. Shielded wires are
recommended.
The wires are soldered to a PCB installed on the switch. This operation can
be carried out before installation.
On the ELT side, the wires are soldered to a 12-pin plug that can be either
a standard "DIN12 connector" (P/N S1820514-03) or a connector with an
integrated serial memory module called "Programming Dongle"
(P/N S1820514-01).
Mount and install RCP
Refer to Figure 19: RC102 mounting diagram, page 23 .
NOTE: Pins of LED must be protected by heat shrinkable sleeves.
Front plate (1a)
• Place the front plate (1a) on the instrument panel and use it as drilling
mask or;
• Trace the centers of the two holes according to drilling mask supplied;
• Drill a hole Ø 8 mm for the LED mounting (2) (top of the panel);
• Drill a hole Ø6.5 mm for the switch (3b) (bottom of the panel);
Note: the switch (3b) is already soldered to a PCB (3a)
• Tear off protection of front plate (1a) from self-adhesive film;
• Stick the front plate (1a) onto the instrument panel;
• Install the LED mounting (2), with washer (2a) and nut (2b). Tighten
nut;
• Connect the anode (long pin) of LED (2c) to A of PCB (3a);
• Connect the cathode (short pin) of LED (2c) to C of PCB (3a);
• Connect wires to K and M of PCB (3a);
• Insert the LED into the LED stand (2d) taking care the flat part of the
LED be in front of the flat part of the LED stand;