Kanga PW628, Руководство оператора

Страница: 48 / 69

48
FUEL FILTER FOR E 10 ETHANOL FUELS – Part Number # DL-001253
The Racor fuel fi lter if maintained daily and correctly will minimize the ingress of water and hard
partials entering into the carburettor and causing corrosion and the engine to run rough.
The 10 micron
fi lter must be drained daily or at prior intervals if it becomes saturated with water so
the operator must keep an eye on the fi lter saturation level, when water is visible in the see through
bowl or engine performance is noticeably reduced service is required.
The aqua block fi lter can be cleaned and re used several times and replaced every 100 hours as
per service chart however if it becomes dirty and completely blocked with hard partials it should be
replaced sooner.
SERVICE INSTRUCTIONS
1. Make sure the engine is turned off and cool to touch.
2. Use a small catch container under the
fi lter housing spin the see through bowl off the mounting
head by turning in a counter clockwise motion.
3. Remove the aqua block fi lter and clean in a bath of Methylated spirits and thoroughly dry (do
not use compressed air or you could damage the fi lter) re install or replace element if required
with part number DL-001253 .
4. Lubricate the fi lter bowl o-ring with motor oil and tighten by hand only don’t use tools
5. Start engine and check for leaks correct any if necessary with the engine switched off.
NOTE: For Ethanol fuels that are stored for longer than 2 weeks and up to a Month a Fuel stabilizer
additive is available P/N CONS-000732 and recommended to reduce phase separation of the
Ethanol fuels.
FUEL FILTER FOR DIESEL FUELS – Part Number # L120400A
Replace the fuel fi lter after every 100 hours of operation, or sooner if operating in a
dusty environment.
IDLE SPEED
Check engine idle speed after every 200 hours of operation, and adjust if out of speci fi cation. See
Engine Manual for details.
SPARK PLUGS (PETROL ENGINE) – Part Number # KS-000027
Replace after every 100 hours.
GLOW PLUGS (DIESEL ENGINE) – Part Number # L115950-3
See Engine Manual for details.
VALVE CLEARANCES (PETROL ENGINE)
Check and adjust engine valve clearances after every 200 hours of operation. See Engine Manual
for details.
VALVE CLEARANCES (DIESEL ENGINE)
Check and adjust engine valve clearances after every 800 hours of operation. See Engine Manual
for details.