KAMA KM2V80, Руководство по эксплуатации

Страница: 13 / 22

(4) Governor
Controls the engine speed via the control lever. It is linked with the accelerator
system on the driven machine side (accelerator handle and pedal to be procured
by the users) by means of an accelerator wire for remote control.
Move the control lever upward to raise the speed, or downward to decrease it.
Maximum and minimum speeds are restricted by the speed limiting bolts.
(5) Alarm lamp
These lamps notify abnormal states during the engine operation.
Charge warning lamp The lamp is off while the battery is recharged. It goes on
when the battery is not charged normally.
Lube oil pressure warning lamp This lamp comes on if an abnormally low lube
2
oil pressure 4.9 kPa (0.5kgf/cm ) or below is detected by the pressure sensor.
Water temperature warning lamp This lamp lights when the cooling water
temperature rises above 110 .
- -
Accelerator wire
Control lever
Speed limiting bolt
Check Replace Consult KAMA dealer or distributor
Initial Later
50h 200h 400h 1000h 2000h
Check item System
Daily
checks
Periodic check intervals
Fuel tank oil level check and addition
Fuel leak from fuel tank
Draining from fuel tank
Fuel filter replacement
Lube oil level
Lube oil leak
Lube oil replacement
Lube oil filter element replacement
Check & addition of cooling water
Rediator fin cleaning
Cooling water replacement
Accelerator operation
ldling speed adjustment
Alarm operation check
Fuel injection pump maintenance
Fuel oil
Lube oil
Cooling
water
Rubber
hoses
Operating
system
Intake
system
Electrical
parts
Cylinder
head
Fuel valve
pump
Cooling water path flushing &
maintenance
Fuel oil pipe & cooling water
pipe replacement
Air cleaner element cleaning &
replacement
Battery electrolyte check &
recharging
Fuel injection timing check &
adjustment
Intake and exhaust valve head
clearance adjustment
lntake and exhaust valve seat
lapping
Injection valve pressure check &
adjustment
or 2 years
Cleaning
Initial Later
- -