KAMA KM2V80, Руководство по эксплуатации

Страница: 21 / 22

This section describes the procedures for starting, adjusting the speed and
stopping the engine and the preparation before keeping the engine in storage for
a long time.
Never drink alcohol before operation
Never operate the engine while you are under the
influence of alcohol or when you are ill or feel unwell as it
results in unexpected accidents.
Exhaust gas poisoning
Do not block the ventilators, ventilation windows and
holes, Provide good ventilation while the engine is
running. Exhaust gas can be very toxic.
Avoid operation in a closed room, tunnel, manhole,
underground or in a ship's hold. Exhaust gas cannot get
out.
Keep away from rotating parts
Keep your hands, body and clothes sufficiently away
from the rotating parts, cooling fan ,V-belt, pulley, etc.
during operation. Serious injury will result if trapped by
these rotating parts.
Do not operate the machine when any of its protective
covers is removed.
Check before starting the engine to see that no tools or
cloth used in maintenance remains.
Beware of scalding from contact with hot engine
parts
Be careful not to touch the turbocharger, exhaust
manifold, exhaust pipe, engine body during operation or
immediately after stopping. Never touch these parts with
your body or clothing. Otherwise, scalding will result.
4. OPERATION
WARNING
CAUTION
WARNING
- -
4.2 Starting
4.2.1 Normal starting procedure
Start the engine as shown below.
1. Release all clutches and turn the starting switch to OFF to cut off the driven
machine load.
2. Open the cock of the fuel tank.
3. Turn the battery switch on.
4. Insert the key into the starting switch.
5. Turn the key from OFF to the ON position. Check all alarms are normal.
6. Set the accelerator (control lever) at the LOW position.
7. Turn the key to the START position to start the engine. When the engine starts,
release the key. The key automatically returns to the ON position.
One starting switch operation should not exceed 15
Seconds. Any longer attempt will overheat the starting
motor.
4.2.2 Starting at low ambient temperature
If the engine is hard to start in cold weather (approx. 0 or below), use the glow
plug for easier starting.
Follow steps to of the above procedure, and then follow the steps below.
8. Turn the key from the OFF to the HEAT and stay there for approx. 15 seconds
until the glow plug is heated up.
9. Turn the key to the START position. After the engine starts, release the key.
NOTICE
- -
Before & in operation
STOP
HEAT
HEAT
OFF
ON
START
Starting switch
Release the key
after starting