KAMA KM2V80, Руководство по эксплуатации

Страница: 16 / 22

3.2 Supplying the Fuel Oil
Beware of fire from oil ignition
be sure to use the correct type of fuel when refueling.
Filling of gasoline or the like by mistake may cause ignition.
be sure to stop the engine before refueling.
if spilt, wipe such spillage carefully.
Never place oil or other flammable material near engine as this could result in
ignition.
3.2.1 Filling up the fuel tank
Fill the fuel tank with clean fuel oil not contaminated with dust or water. The tank
should be filled to approx. 90% of the full capacity. Be careful not to spill it during
operation.
3.2.2 Bleeding air from the fuel system
unless there is air in the fuel system the fuel cannot be fed to the fuel injection
pump.
This engine has an automatic bleeding system. Bleed air from the fuel system
according to the following procedure:
1. Check the oil level in the fuel tank. Add the fuel if insufficient.
2. Open the cock of the fuel tank.
3. Turn the starting switch key to the ON position. The fuel feed pump operates to
feed the fuel, and when the fuel filter is filled with fuel without any air space or
bubbles, the engine is ready to be started.
- -
NOTICE
If draining is neglected, the water remaining in the
system in cold weather is frozen to damage the cooling
water system components (radiator, cylinder block,
cylinder head, etc.)
3. Exterior cleaning, fuel draining, and filling
Clean dirt and oil off from the engine exterior wall.
Thoroughly drain fuel or completely fill the fuel tank for preventing condensation.
Lubricate joints and pivots of the accelerator system.
4. Water-and dust-proofing
Protect the air cleaner, silencer and electrical parts (alternator, starter, switch)
from water and drain with airtight plastic covers.
Store the engine at a well ventilated place not subject to high moisture or dust.
5. Measure against battery self-discharging
Turn the battery switch off or disconnect the ground lead (-) of the battery.
Recharge the battery monthly to compensate for the self-discharging.
4.6.2 Pre-operation check after long storage
For operation after long storage, make the same preparations as for the initial
operation. Refer to Section 3-Before Operation.
- -