
Full digital mechanical sector scanning ultrasonic diagnostic instruments (Vet) User’s Manual V1.07
- 7 -
Straps
Buckle
Battery
the lower case
of main unit
5.3 Connection to shutter release
Install shutter release to shutter release interface (Freeze interface) as shown in the figure.
5.4 Connection to power
1. Connect to the power adapter
Insert the output plug of adapter into DC power input port, which is on the right side of
main unit.
2. Connect to the main power supply
Insert the power plug (jack) furnished with the machine into power input socket of the
power adapter, the other end to the mains socket-outlet. The instrument uses three-core
power supply. It connects with the protective earth line when power plug inserts into the
standard power socket.
5.5 Ultrasonic probe check before and after operation
Before and after ultrasonic diagnosis to check if there are any exceptionally on the surface of
the probe or cable jacket, such as peeling, cracks, bulge, or if the acoustic lens is reliable, cleaned
or disinfected.
5.6 Main unit check before and after operation
5.6.1 Inspection before start-up
Check the following items before starting the machine:
Warning:
1. Adapter has no switch. APPLIANCE COUPLER or MAINS PLUG is used as the
intended disconnection device from the supply mains. Do not position the
EQUIPMENT the place where it is difficult to operate the disconnection device.
2. AC/DC adapter is as a part of the equipment, please only use the AC/DC adapter
provided by Kaixin Company.
3. To avoid damaging power adapter or harming people by unexpected fallen, make sure
the power adapter is placed on the leveled desk.
4. The operator must not touch signal input/output and patient simultaneously.
Warning:
Do not short-circuit the battery terminals.