Page 15
Instruction manual - G95
Kivex Biotec Ltd
RS232
The RS232 option is for serial communication and data logging of the
temperature
and alarm conditions.
Follow these steps to navigate in the RS232 option.
Action
Key
Display
Press and hold UP+DOWN key for 3
seconds to enter the the menu.
The option "UNIT" will appear in the
display.
Press DOWN key until the option "RS232"
appears in the display.
Press and hold setpoint key to change
values.
While holding the setpoint key in, press
either the arrow UP or arrow DOWN key to
select between "ON" and "OFF".
"OFF" : The RS232 function is turned off.
"ON": Data is send once every two seconds.
When the required setting is activated, let
go of the setpoint key.
Press and hold UP+DOWN key for 3
seconds to exit the the menu.
Data logging the temperature valves during use:
Note
The RS232 cable must be connected before start.
Follow the steps in the table above and choose "ON".
Choose one of the settings to get the required data
S-1
Sends the data for the last one hour.
S-2
Sends the data for the last two hours
send
Sends the data for the last five hours.
Note
The use of this function warrants extra equipment software (Ver. 3) and on some base
models addition of a Serial PCB. The parameters on or off will not affect normal usage
when serial communication is not connected.
