JW Fishers SCAN-650, Руководство по эксплуатации

Страница: 30 / 47

30
INSTALLING HARDWARE AND SOFTWARE (PC-CARD or PCI board)
For PC-CARD on Laptop PC:
Before the SCAN-650 can be used for the first time, this program must be run to
configure and calibrate the Interface board. This program must also be run whenever the Inter-
face board is installed in a different Laptop PC. The Interface board must be installed before
running this program.
1. From the Start menu select Programs / Measurement Computing / InstaCal.
2. The InstaCal software starts.
3. In the ‘PC Board list’ click on ‘PC-CARD-DAS16/330’ to highlight it.
4. From the ‘Install’ pull-down menu click on ‘Configure’. The ‘Board Configuration’ box opens.
5. • Next to ‘Clock 0 Source’, select ‘External’.
• Next to ‘Clock Speed’, select ‘10MHz’.
• Next to ‘ADC External Pacer Edge’, select ‘Rising’.
• Click ‘OK’ to continue.
6. From the ‘Calibrate’ pull-down menu click on ‘A/D’. The automatic calibration will begin.
Allow the calibration to complete. When calibration is complete, click ‘OK’.
7. Exit the InstaCal program.
For PCI board (Desktop PC)
Before the SCAN-650 can be used for the first time, this program must be run to configure and
calibrate the Interface board. This program will also need to be run if the Interface board has
been removed and replaced in the PC or moved to a different slot on the motherboard. The
Interface board must be installed before running this program.
1. From the Start menu select Programs / Measurement Computing / InstaCal.
2. The InstaCal software starts.
3. If the Interface board is properly installed, the ‘Plug and Play Board Detection’ box will
open. Be sure there is a checkmark in the box next to ‘PCI-DAS1200Jr’. Click ‘OK‘ to con-
tinue.
4. In the ‘PC Board list’ click on ‘PCI-DAS1200Jr’ to highlight it.
5. From the ‘Install’ pull-down menu click on ‘Configure’. The ‘Board Configuration’ box opens.
6. • Next to ‘No. of Channels’, select ’16 Single Ended’.
• Next to ‘ADC Ext Pacer Edge’, select ‘Rising’.
• Next to ‘Counter 4 Source’, select ‘External’.
• Click ‘OK’ to continue.
7. From the ‘Calibrate’ pull-down menu click on ‘A/D’. The automatic calibration will begin.
Allow the calibration to complete. When calibration is complete, click ‘OK’.
8. Exit the InstaCal program.
Skip to page 31 if your SCAN-650 Sonar Processor connects to the PC using a USB cable