30
Adjusting the equalization patterns
—DIGITAL EQ 63Hz/250Hz/1kHz/4kHz/16kHz
You can adjust equalization patterns in five frequency bands
(center frequency: 63 Hz, 250 Hz, 1 kHz, 4 kHz, 16 kHz) for the
front speakers.
• Once you have made an adjustment, it is memorized for each
source.
Adjustable range:
–8 (dB) to +8 (dB) (in 2 dB intervals)
Initial setting:
0 (dB) for all bands
• When adjustment is made, the EQ indicator lights up on the
display.
If no adjustment is required,
set all the frequency bands to
“0 (dB).”
• The EQ indicator goes off from the display.
From the remote control:
You can also make adjustments the following way from the
remote control.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
2
again.
Set the mode selector to “AUDIO/TV/VCR/DBS.”
1
Press SOUND.
2
Press EQ FREQ repeatedly to
select the band you want to adjust.
3
Press EQ LEVEL
9
/
(
to adjust
the equalization pattern of the
selected band.
4
Repeat steps
2
and
3
to adjust
other bands.
NOTE
After pressing SOUND, the numeric
buttons work for sound adjustments. To
use the numeric buttons to operate your
target source, press the corresponding
source selecting button before operation;
otherwise, the remote control may not
work as you intend.
Adjusting the bass sounds
7
Reinforcing the bass—BASS BOOST
You can boost the bass level—Bass Boost.
• Once you have made an adjustment, it is memorized for each
source.
BASS BOOST: ON
Select to boost the bass level.
The BASS indicator lights up on the display.
BASS BOOST: OFF
Select to deactivate the Bass Boost.
Initial setting:
BASS BOOST: OFF
NOTE
This function affects only the sound coming out through the front
speakers.
From the remote control:
You can also make adjustments the following way from the
remote control.
Set the mode selector to “AUDIO/TV/VCR/DBS.”
Press SOUND, then press BASS
BOOST repeatedly.
• Each time you press BASS BOOST, the
Bass Boost turns on and off alternately.
NOTE
After pressing SOUND, the numeric
buttons work for sound adjustments. To
use the numeric buttons to operate your
target source, press the corresponding
source selecting button before operation;
otherwise, the remote control may not
work as you intend.
7
Selecting the subwoofer sound phase—
SUBWOOFER PHASE
You can change the subwoofer sound phase to your preference.
• Once you have made an adjustment, it is memorized for each
source.
PHASE: NORMAL
Normally select this.
PHASE: REVERSE
Select this when you feel the bass sound is
better with this mode rather than with
“PHASE: NORMAL.”
Initial setting:
PHASE: NORMAL
NOTE
This function takes effect only when “SUBWOOFER” is set to
“SUBWOOFER: YES” (see page 21).
7
Attenuating the input signal—INPUT ATT
When the input level of
analog source
is too high, the sound will
be distorted. If this happens, you need to attenuate the input
signal level to prevent the sound distortion.
• Once you have made an adjustment, it is memorized for each
source.
INPUT ATT: ON
Select to attenuate the input signal level.
The ATT indicator lights up on the display.
INPUT ATT: NORMAL
Select to deactivate attenuation.
Initial setting:
INPUT ATT: NORMAL
3
1
2
EN26-31RXF31S[A]1.p65
05.6.13, 10:37
30
