JVA ELECTRIC FENCE SYSTEMS
31
JV
A Z114 L
CD K
eypad F
ea
tur
es
8.1.2 Menus
The Z series keypad has an optional menu driven interface. The main menu is
accessed by pressing the Menu (Bypass) key (bottom right). You will be asked to enter
your PIN, and then press #.
Most functions are available via the menus. Use the 2 key to go up and the 8 to step
down through a menu. The Enter (#) key is used to select the current line.
The menu will time out after a few minutes and return to the normal status display.
The menu system was added in keypad code version 2.10
8.1.3 Keypad Status Display
In normal operation the keypad shows a continuous summary of the system status. For
example if the system is disarmed the keypad will display “Ready to Arm”.
If the system is armed then the keypad will display the voltages for each zone in the
system.
Since there can be many things to display the keypad automatically “scrolls” through
all relevant detail. Each screen is show for about 2 seconds. If you wish to hold the
display at a particular point simple press the [#] key. The auto scrolling will stop for
about 20 seconds.
Pressing the [#] key again will advance the display one step.
If a new trouble (AC fail, low battery etc) or alarm occurs, the keypad screen will jump
to the relevant zone, the keypad will beep (unless toggled off) and auto scrolling will
cease for about 3 minutes.
8.1.4 Changing the Keypad Messages and Address
You can change the messages and each of the zone labels.
• The Dealer Message displays when the system is on standby.
• Zone Labels displays after the [#] key is pressed during alarm memory or faults.
• The programmable Service Message is displayed during AC failure,
communication failure, or low battery.
[1]
[2] Character up
[3] not used
Emergency not used
[4]
Cursor left [5] Next Message
[6]
Cursor right Fire not used
[7]
[8] Character down [9]
Panic not used
[*]
[0] Last Message
[#] Enter/Exit
Bypass not used
Keys used for changing messages
