Juniper ULTRA-RUGGED FIELD PC, Справочное руководство, Страница: 34 / 170

26
3. Pull off the standard cap.
4. Insert the CF or SD card.
Note: For instructions on replacing the standard cap,
see the section in this chapter called
Reattaching the
standard cap.
Installing a CF or SD card.
To operate a card, insert
the card into the appropriate card slot, located under
the standard cap of the Field PC. (See the instructions in
the previous section for removing the standard cap.) The
system should automatically detect and use the card.
However, if the card is not recognized, try the following:
1. Install an appropriate driver by following the
directions on the device screen.
2. Operate the card by consulting the user’s guide that
came with the card.
Reinserting or changing a CF or SD card. Whenever
you remove or change a CF or SD card on the Field PC,
wait at least 6 seconds before inserting another card
into the slot. The Field PC needs this short time delay
to properly identify and use the newly inserted card. If a
card is re-inserted too quickly, the Field PC may need to
reset. To avoid this problem, close all programs before
changing or re-inserting a card.
Copying data from a CF card, SD card, or USB drive.
You can run or copy data from a peripheral device onto
your Field PC by following these steps:
1. On the Field PC, tap
Start
>
Programs
>
File Explorer.