Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 13 / 60

Back Panel
„ 13
Chapter 1: Hardware Overview
2. Save the files from the USB storage device to the internal flash storage on the
device with the
save { software | config | image-key } from usb filename to
flash command.
3. Stop the USB port with the exec usb-device stop command before removing
the USB storage device.
4. Remove the USB storage device.
If you want to delete a file from the USB storage device, use the delete file
usb:/filename command.
If you want to view the saved file information about the USB storage device and
internal flash storage, use the
get file command.
Back Panel
The back panel of the SSG 140 device contains four physical Interface Modules
(PIM) slots and the power panel.
Figure 4: Back Panel of an SSG 140 Device
The following sections describe the elements on the back panel of the SSG 140
device:
„ “Physical Interface Module Slots” on page 13
„ “Power Switch” on page 14
„ “AC Power Appliance Inlet” on page 14
„ “Fuse Cover” on page 14
Physical Interface Module Slots
Physical interface modules (PIMs) let you add Ethernet and WAN interfaces to your
SSG 140 device. For information about installing and removing PIMs, see
“Replacing a PIM” on page 38. For more information about PIMs, refer to the
PIM
and Mini-PIM Installation and Configuration Guide.
CAUTION: Always execute the exec usb-device stop command before
disconnecting a USB storage device. Disconnecting a USB device without
executing the
stop command may cause the device to restart.
E1
PORT 0
STATUS
PORT 1
STATUS
E1
PORT 0
STATUS
PORT 1
STATUS
I
O
PIM Slot 1
PIM Slot 2
PIM Slot 3
PIM Slot 4
Power Panel