Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 43 / 60

Replacing the Fuse
„ 43
Chapter 4: Servicing the Device
13. To replace the top panel on the chassis, set the rear edge of the top panel into
the groove that runs along the top rear edge of the chassis. Then lower the top
panel onto the chassis.
14. Slide the top panel back 1/2-inch (13mm).
15. Use the number-2 phillips screwdriver to replace and tighten the screws you
removed earlier, securing the top panel to the chassis.
16. Use the screwdriver to replace and tighten the screws securing the rack mount
brackets to the sides of the chassis.
17. Replace the SSG 140 in the equipment rack.
Replacing the Fuse
The SSG 140 device uses a 6.3 amp fast acting fuse rated for 250 volts.
To replace a failed fuse on the SSG 140 device:
1. Take the device off-line, turn the power switch OFF, and disconnect the power
cable.
2. Using a flat-tip screwdriver, separate the lid of the external fuse cover from the
surface of the power outlet.
Figure 14: Removing the Fuse
I
I