Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 14 / 60

SSG 140 Series Hardware Installation and Configuration Guide
14 „
Back Panel
Power Switch
The power switch is located on the right side of the back panel, as shown in
Figure 5. You use the power switch to power the SSG 140 device on and off. When
you power on the device, ScreenOS starts up as the power supply completes its
startup sequence.
Figure 5: Power Switch, AC Power Appliance Inlet, and Fuse Cover
AC Power Appliance Inlet
The AC power appliance inlet is located on the right side of the back panel, as
shown in Figure 5. You use the AC power appliance inlet to connect the SSG 140
device to an AC power source (90-264 VAC 50-60 Hz)
using the supplied AC power
cord.
Fuse Cover
The fuse cover is located on the right side of the back panel, as shown in Figure 5.
To change the fuse, see “Replacing the Fuse” on page 43.
CAUTION:
PIMs are not hot-swappable. Always switch off the device before
inserting or removing PIMs.
Power
Switch
AC Power
Appliance Inlet
Fuse Cover