Figure 32: Configuring SNMP
3.
Select the version of SNMP to be used, either
v2c
or
v3
.
4.
Provide authentication information:
•
If you selected SNMP v2c, enter a username.
•
If you selected SNMP v3, enter a username and password.
The password must be at least 8 characters long.
NSMXpress implements a single username and password, which is effective only
for SNMP communication and is not related to any other username and password
used on the NSMXpress appliance.
5.
To limit SNMP Get requests to specific servers, select
Only
, and then enter the IP
addresses of the permitted servers.
6.
Click
Save
.
SNMP System Information
To configure SNMP system information:
1.
Select
System Administration > SNMP Monitoring
.
2.
Select the
System Info
tab, which is shown in Figure 33 on page 29.
Figure 33: Configuring SNMP System Information
3.
Enter the following information, which is required for any SNMP-managed device:
•
Contact—Contact information for the appliance.
•
Location—Location of the appliance.
29
Copyright © 2010, Juniper Networks, Inc.
Managing System Administration
