Figure 31: Edit RADIUS Server Dialog Box
3.
Edit the parameters you want to change and click
Save
.
Monitoring with SNMP
You can configure your NSMXpress appliance for SNMP monitoring from a network
operations server. The server can then issue periodic SNMP Get instructions to return the
status of the NSMXpress appliance.
You configure SNMP on the NSMXpress appliances with access credentials for either
SNMP v2c or SNMP v3. NSMXpress supports read-only access to the System Descriptor
(sysDescr) and Host Resource MIB.
This section provides instructions for configuring NSMXpress for SNMP monitoring. You
must provide access credentials for the SNMP server, a list of IP addresses from which
logon requests will be accepted, and the trap conditions to be reported to the SNMP
server.
To configure SNMP monitoring of your NSMXpress appliance, select
System
Administration > SNMP Monitoring
. The SNMP window appears. This window contains
the tabs described in the following sections:
•
SNMP Configuration on page 28
•
SNMP System Information on page 29
•
SNMP Trap Configuration on page 30
SNMP Configuration
To configure SNMP:
1.
Select
System Administration > SNMP Monitoring
.
2.
Select the
SNMP Config
tab, which is shown in Figure 32 on page 29.
Copyright © 2010, Juniper Networks, Inc.
28
NSMXpress Quick Start
