Juniper EX4100, Руководство по оборудованию

Страница: 263 / 283

Prevention of Electrostatic Discharge Damage
Device components that are shipped in antistatic bags are sensitive to damage from static electricity.
Some components can be impaired by voltages as low as 30 V. You can easily generate potentially
damaging static voltages whenever you handle plastic or foam packing material or if you move
components across plastic or carpets. Observe the following guidelines to minimize the potential for
electrostatic discharge (ESD) damage, which can cause intermittent or complete component failures:
• Always use an ESD wrist strap when you are handling components that are subject to ESD damage,
and make sure that it is in direct contact with your skin.
If a grounding strap is not available, hold the component in its antistatic bag (see Figure 116 on page
255 ) in one hand and touch the exposed, bare metal of the device with the other hand immediately
before inserting the component into the device.
WARNING: For safety, periodically check the resistance value of the ESD grounding
strap. The measurement must be in the range 1 through 10 Mohms.
Avertissement Par mesure de sécurité, vérifiez régulièrement la résistance du bracelet
antistatique. Cette valeur doit être comprise entre 1 et 10 mégohms (Mohms).
• When handling any component that is subject to ESD damage and that is removed from the device,
make sure the equipment end of your ESD wrist strap is attached to the ESD point on the chassis.
If no grounding strap is available, touch the exposed, bare metal of the device to ground yourself
before handling the component.
• Avoid contact between the component that is subject to ESD damage and your clothing. ESD
voltages emitted from clothing can damage components.
254