Operation
18/30
4156 EN
Equalisation once/perman.:
If a compensation charge is to be carried out after the normal charge, the equalisation
charge function must be activated prior to charging. Select the Equalisation once
function in menu item Functions>Battery service and confirm with OK. When the
Equalisation once function is activated, a compensation charge is then carried out after
the next charge. If the Equalisation perman. function is activated, a compensation
charge is performed after every charge.
Z
Z
Z
Z
Note
The compensation charge starts 24 hours after the start of the normal charge.
For some charging programs a compensation charge is included as standard. In this
case the compensation charge cannot be activated.
6.1.6
Function – Measured values
The Measured values function allows you to set how many and which measured values
are displayed in the graphic display during charging. See also Table 5.
6.1.7
Graphic Display Information
Information on the default settings of the charger and charging end data can also be
taken from the graphic display, see following table:
Menu item
Information
Sample value
Battery-info
Battery nominal volt.
80V
Battery capacity
200 Ah
Charging program
LP2 (E)PzS
Basic setting
Release information
SLH 200
V1.3 605676.03
History
End of charge data
Voltage:
2,7 V/Z
Current:
10,2 A
Charged Ah:
250,0 Ah
Charging time:
08:00 h
Time:
12:00
Date:
01.07.2004
Error messages
Power consumption
Last cycle
20 kWh
Total
100 kWh
Statistics
No. of charge cycles
No. of charge finished
No. of forced switch over
No. of safety switch off
No. of pump failures
Table 6: Graphic Display Information
6.1.8
Parameters – Consumption data
The History>Power consumption menu item shows how many kWh were taken from the
mains in the last charge and overall.
