Jungheinrich DFG 660, Руководство по эксплуатации

Страница: 85 / 221

11
.1
4
E
N
86
5 Preparing the Truck for Operation
5.1 Checks and operations to be performed before starting daily
operation
WARNING!
Damage and other truck or attachment (optional equipment) defects can result
in accidents.
If damage or other truck or attachment (optional equipment) defects are discovered
during the following checks, the truck must be taken out of service until it has been
repaired.
X Report any defects immediately to your supervisor.
X
Mark defective truck and take out of service.
X Do not return the industrial truck to service until you have identified and rectified the
fault.
CAUTION!
Checking the accelerator pedal
X The accelerator pedal should only be
checked when the parking brake is
applied and the engine is idle.
Checks before daily operation
Procedure
• Visually inspect the entire truck (in particular the wheels, wheel bolts and load
handler) for damage.
• Check the fork stop (167) and fork tine retainer (168).
• Visually inspect the hydraulic system in the visible area for damage and leaks.
• Check the driver’s seat has been adjusted to the correct position.
• Test the horn and reversing buzzer (
o
) where applicable.
• Check that the load chart and warning labels are legible.
• Test the controls and displays.
• Test the steering.
• Make sure the load chains are evenly tensioned.
• Test the seat belt. (The belt should jam if extracted suddenly.)
• Test the seat switch. When the driver’s seat is vacated it should not be possible to
activate the working hydraulics.
• Test the restraint system (
o
),
• Test the lift/lower, tilt and if applicable the attachment hydraulic control functions.
• Check the accelerator pedal can move freely by pressing it several times.
• Test the service brake and parking brake: Start driving carefully and test the
effectiveness of the brake pedal.
• Check the fuel supply.
• Check the fluid level of the window washer system (
o
), see "Adding Window
Washer System Fluid" on page 182.
168
167