Jungheinrich DFG 660, Руководство по эксплуатации

Страница: 216 / 221

217
11
.1
4
E
N
Hydraulic operations W A B C
1
Test "hydraulic" controls and make sure the labels are present,
legible and complete.
t
2
Test hydraulic controls and check they are assigned to the correct
functions.
t
3
Check cylinders and piston rods for damage and leaks, and make
sure they are secure.
t
4
Check running surfaces of the integral sideshifter and / or integral
fork positioner for wear and damage, and lubricate if necessary.
t
5
Check settings and wear levels of slide pieces and stops and adjust
the slide pieces if necessary.
t
6 Check load chain setting and tension if necessary.
t
7 Check load chain lubrication and lubricate if necessary.
t
8
Check lateral clearance of the mast connections and the fork
carriage.
t
9
Visually inspect the mast rollers and check contact surface wear
level.
t
10
Check running surfaces of the mast for wear and damage, and
lubricate if necessary.
t
11 Test hydraulic system.
t
12 Replace hydraulic reservoir discharge paper filter.
t
13 Replace hydraulic oil filter.
t
14
Check that hydraulic ports, hose and pipe lines are secure, check for
leaks and damage.
t
15 Test emergency lowering system.
t
16 Check hydraulic oil level and top up if necessary.
t
17 Test relief valve and adjust if necessary.
t
18 Replace hydraulic oil.
t
19 Check forks or load handler for wear and damage.
t
20
Check piston rod screw depth and counter fixing / clamp. Where two
tilt cylinders with the same stroke length are used, check the setting
in respective of each other.
t
21 Check tilt cylinders and mounting.
t
22 Test lift and lowering speeds.
t
Agreed services W A B C
1
Carry out a test run with rated load, if necessary with a customer-
specific load.
t
2 Lubricate truck according to the lubrication schedule.
t
3 Demonstration after servicing.
t