digital audio
modular
processing system
C8000
4/8/16 channels DSP with SDI & system-bus I/O
C8492(B)
page
8/30
The C8492 has 3 banks of Presets:
DSP /
Routing
SDI / Failover/Upmix
The status window on the left hand side shows the names of the active presets. The word “modified”
will appear in line with the preset name if any preset parameter was changed since loading this preset.
DSP
Is dedicated to audio processing (Leveler, Compressor / Limiter /
Expander / Fail Over / Upmix).
Load
Select a preset by name and press <LOAD>.
Loaded from preset
The soft LEDs show the channels which will be controlled by the
active preset. The number of soft LEDs depends on the program
configuration. E.g. channels 1-6 are represented by one soft LED
because they belong to a 5.1 program while 7/8 represent a stereo
program as well as 9/10 and 11/12. Channels 13, 14, 15, 16
belong to mono programs whereas channel 15, 16 are not part of
the preset currently loaded.
Here another example where channels 15 and 16 are not part of
the actual loaded preset:
Save as #
Select a preset NV memory number.
Name
Assign the preset a name (up to 16 digits).
and press <SAVE>.
Channels stored
The check boxes define which channels will be stored when you
in presets
save a preset. The number of check boxes depends on the
program configuration.
Here an example where DSP1 (Ch 1 – 8) is set for 5.1 + 2
operating mode and DSP 2 (Ch 9 – 16) is set for 4 x 2 operating
mode. Ch 9/10 and 11/12 are linked for stereo operation and
13, 14, 15, 16 are not linked (mono mode). The parameters of
channels 15 and 16 will not be stored:
Routing/SDI
controls the SDI Embedder / De-Embdder including delays and the
bus routing if the (B) option is activated.
Load
Select a preset by name and press <LOAD>.
The soft LEDs show which part (SDI and / or Input Bus Routin) is
affected by the currently loaded preset.
