Menu functions
38
Initiation and exit of the editing function:
x
After the start enter the submenu „3 EDITOR“.by pressing the key
See chapter „program administration, creation“ page 40
x
Exit the editing modus anytime by pressing the key
.
Particularity for changes in a section that is currently in process
.
L
If the target temperature is changed, the slope of the ramp is
automatically calculated based on the remaining time of the section.
L
If the time period is changed, the slope of the ramp is automatically
calculated based on the new total time of the section.
L
The “remaining total time” (profile x number of repetitions) as
described on page 37 can no longer be displayed.
9.1.4.
Interrupting a program
L
Press the
key to interrupt or continue a profile.
The setpoint and time period set for the corresponding section are
thus stopped at the values presently achieved.
The instrument is put on hold and the message “pause” flashes on
the LCD DIALOG DISPLAY.
L
A program can be interrupted or restarted by an external shut-off.
Important:
For this, in the >
Inputs/Outputs
< menu, the menu item >
Ext. StBy
<
must be set to >
active<
and in the >
Configuration
< menu, >
Autostart<
needs to be set
L
Setpoint control and timer are interrupted by breaking the contact
“AK”.
The instrument is put on hold and the message “Stand-By” flashes
on the LCD DIALOG-DISPLAY.
Notice:
T
his is not an actual emergency switch-off.
Warning:
Following a power interruption, it would be possible in this condition for the instrument
to restart automatically. The safety and warning functions of the instrument should
always be used to their fullest capacity.
See
Warning
page 49 .
AK
1
2
3
STAND-BY
www.
GlobalTestSupply
.com
Find Quality Products Online at:
