Jula Hard Head 018980, Руководство по эксплуатации

Страница: 59 / 120

EN
35
TOOLS
FIG. 7
INSTALLATION
Chain package
1. Put one end of the chain through the
opening between the sprocket (2) and the
sprocket fork (1) and lay the chain round
the sprocket (2).
2. Connect the ends of the chain with the
chain lock (3).
3. Fit the sprocket fork (1) in the guide
section with holes.
FIG. 8
Fitting the drive unit
1. The drive unit consists of the sprocket (2),
bracket (3) and boom junction sleeve (4),
and is supplied fully assembled from the
factory.
2. Fasten the chain in both ends of the
carrier (6) and put the carrier in the
guide. The carrier (6) should be fastened
in the chain lock (5).
FIG. 9
NOTE:
The release arm (7) should be directed
towards the drive unit.
3. Place the chain round the sprocket (2)
and fit the drive unit in one of the holes in
the guide.
Fitting the guide
1. Place the guide (1) parts on a level
surface. The four sections can be installed
in an optional order.
2. Put a joining piece (2) on a guide section.
Connect the guide sections together by
fitting a joining piece on the next guide
section. Knock the guide sections together
by knocking the ends of the fitted guides
Overhead door with horizontal
guide
1. Wall over door
2. 5 cm
3. Door leaf
4. Highest point reached
5. Guide
FIG. 3
Up and over door with arch shaped
guides
1. Wall over door
2. 5 cm
3. Door leaf
4. Highest point reached
5. Guide
FIG. 4
The door opener can be connected directly to
doors shaped as per figure 3 and 4.
For doors shaped as in figure 5 and 6 an
additional arm is needed (sold separately).
Overhead door without guides:
Side arm
1. Wall over door
2. 20 cm
3. Door leaf
4. Highest point reached
5. Side arm
FIG. 5
Overhead door without guides:
Pivoted suspension
1. Wall over door
2. 20 cm
3. Door leaf
4. Highest point reached
5. Pivoted suspension
FIG. 6