Jula Hard Head 018980, Руководство по эксплуатации

Страница: 63 / 120

EN
39
If additional remote controls are required, the
programming of the door opener must be
supplemented with the codes for these.
NOTE:
Check that the door and door opener are
completely and correctly installed.
Pairing with the door opener
1. Plug in the plug. The letter H flashes in
the display and the light goes on. The unit
is now in standby mode (figure 1).
2. Press the LEARN button on the door
opener for at least 2 seconds. The symbol
• is shown in the display (figure 2). Press
the button on the door opener to be
paired with the door opener twice. The
symbol • flashes on the display and then
the letter H is shown (figure 3).
3. The code for the remote control button is
then transferred to the door opener and
the pairing is complete.
FIG. 21
NOTE:
Repeat the above steps to pair additional
remote controls. The door opener has a
memory for up to 6 remote controls.
Deletion of all codes
Press the LEARN button on the remote control.
The symbol • is shown on the display and then
switches to H. When H starts flashing on the
display the codes are deleted (figure 4 in figure
21).
Using the remote control
The remote control has 4 buttons that can be
paired with 4 different door openers. When a
button has been paired it controls “its” door
opener by repeatedly pressing in the sequence
open - stop - close - stop - open ...
Adjusting the limit position
1. Press the SET button for at least
4 seconds. 1 is shown in the display (figure
1). Tap the SET button again. 1 flashes in
the display (figure 2). The limit position
can now be set.
2. Press the UP button. The motor starts
and begins to drive the door opener
to open position. The symbol n flashes
in the display to show that the door is
opening (figure 3). Release the button
when the door leaf has reached the
required position. The movement stops.
The limit position for open door (upper
limit position) can be set with the UP
and DOWN buttons. Press the SET button
to save the setting when the position to
be the limit position has been reached.
1 is shown in the display (figure 4). The
setting for limit position for open door is
then ready.
3. Press the UP button so that 2 is shown in
the display (figure 5).
4. Tap the SET button. 2 starts flashing in the
display (figure 6). The limit position for
closed door (bottom limit position) can
now be set.
5. Press the DOWN button . The motor starts
and begins to drive the door opener to
closed position. The symbol u flashes
in the display to show that the door is
closing (figure 7). Release the button
when the door leaf has reached the
required position. The movement stops.
The limit position for closed door (bottom
limit position) can be set with the UP
and DOWN buttons. Press the SET button
to save the setting when the position to
be the limit position has been reached.
2 is shown in the display (figure 8). The
product waits for activation of other
positions. Press the SET button for a few
seconds, until H is shown on the display
(figure 9). The setting for limit position for
open door is then ready.
FIG. 22