FX-3R Maintenance Guide
2-14
2-7. Readjustment After Replacement of Head Unit
Table 2-7-1 List of Readjustment Items After Replacement of Head Unit
Laser ID No.
setup
Laser offset
Head offset
Component speed
measurement
Mounting general
offset
Head unit assembly
{
{
{
Z-motor
{
θ
-motor
{
{
Z-sensor
{
LNC60
{
{
{
{
{
Timing belt Z
{
Timing belt
θ
{
{
Z-slide shaft
{
{
{
The MS parameters must be input from the left in order.
When inputting a laser offset after the head unit assembly, Z-motor, and/or timing belt Z have been
replaced, obtain the laser offset again after the height of the top surface of the laser offset board has
been set to “0”. According to the offset value before replacement, the offset cannot be obtained
correctly or it cannot be obtained automatically.
CAUTION
To prevent any personal injury, do not put your hand inside the
machine or your face or head close to the machine during operation
of the touch panel and/or HOD.
Rev. 1.00