Judo 8203040, Инструкция по установке и эксплуатации

Страница: 17 / 40

JUDO i-soft@home 17
Operation
Settings
– Language:
DE, EN, FR, NL, IT
– Desired water hardness (see chapter
5.3.3 “Desired water hardness setting”)
– Correction of the desired water hardness
(see chapter 5.3.5 “Desired water hard-
ness recalibration”)
– Salt top-up quantity, salt reserve
– Leakage alarm on/off (Limit values and
sleep mode time only visible if leakage
alarm is activated.)
– Water hardness unit:
°dH, °e, °f, gpg, ppm, mmol/l, mval/l
– Lighting, contrast, tone
– Functioning of the fault indication relay
(see chapter 5.8 “Potential-free signal
relay”)
– Factory setting
(see chapter 5.14 “Resetting to factory
setting”)
Operating data
– Total raw water volume since commis-
sioning [m³]
– Total number of regenerations since
commissioning
– Total number of services since commis-
sioning
Info
Various information is displayed here such
as the salt reserve and capacity, the device
type, device number, customer service tele-
phone number, history of the warning mes-
sages and fault indications, software ver-
sion, hardware version, the date for the next
necessary service and the current (instanta-
neous) water flow.
5.3 Start of operation
– To shorten commissioning, fill approxi-
mately 5 litres of water into the salt res-
ervoir (until just above the intermediate
bottom).
– Fill 25 - 50 kg of regenerating salt into
the salt reservoir .
The regenerating salt must as a minimum
comply with the requirements of DIN EN 973
and be of food-grade.
Our recommendation: Broxo or Solvay
salt, either as blocks, tablets or coarse
grains 7 - 15 mm. If other regenerating salts
are used, then the salt reservoir
must be
cleaned at shorter intervals and the intake
strainer replaced more frequently.
– Remove the cover.
– Enter the date of installation on the label
(see fig. 12).
– Open the water supply (stopcock or
shut-off valve).
– Ensure that the bypass valve (if in-
stalled) is set to “Operate”.
ATTENTION
For safety reasons, the water softening unit
must be
flushed and regenerated for
venting immediately after water supply is
opened.
Fig. 12: Device and order no. plus label “Date of
installation”
Device no.
Order no.
Label
“Date of installation”