Judo 8203040, Инструкция по установке и эксплуатации

Страница: 27 / 40

JUDO i-soft@home 27
Operation
5.11 Conversions / changes / spare
parts
Only original spare parts may be used!
Unauthorised conversions and changes are
forbidden for safety reasons! They may im-
pair the operation of the water softening unit.
The imprinted approval marks are only valid
if original spare parts are used.
5.12 Service/repair
ATTENTION
Before performing work on the water sof-
tening unit that goes beyond pure opera-
tional use, the water softening unit must be
depressurised!
If this is ignored, the result may be uncon-
trolled egress of water resulting in water
damage to the building/home. Therefore the
instructions given in chapter 4 “Installation”
and chapter 7 “Servicing” must be strictly
observed.
5.13 Interruption of operation
The water supply to the water softening unit
is interrupted. The main stopcock is closed
or the bypass valve is switched over.
– When disassembled, water softening
unit must be stored in a dry and frost-free
location.
– The connection flange must be protect-
ed against dirt and damage.
– Once the water softening unit is fitted
and started again, it must be flushed and
regenerated (see chapter 5.3 “Start of
operation”).
5.14 Resetting to factory setting
All customer settings (e.g. desired water
hardness and residual hardness correction)
can be reset to the factory setting in the fol-
lowing way:
Press the
key 1x and then

2x. The
display shows the following:
Press key <OK> 1x and then key

as often
as necessary, until the display indicates the
following:
Press the <OK> key. The display shows the
following:
Press key

or

to change between
<yes> and <no>.
The following default values are recreated
by pressing key <OK> with <yes> selected:
– Desired water hardness 8 °dH
– Residual hardness correction = 0 (reset)
– Leakage alarm
• Leakage alarm enabled
• max. water volume: 300 l
• max. water flow: 4000 l/h
• max. drawing time: 30 min
– Fault indication relay: NOC function
– Lighting 80 %, contrast 50 %
Pull the power supply unit out of the
socket! (If present, also pull out the
power supply unit of the downstream
dosing pump!)
Main menu
• Settings
Setting
• Factory setting
Factory setting
<no>