V:\Mark\AP-F6 Operation Manual.doc
5
JST
AP-F6 PNEUMATIC CRIMPING MACHINE
REAR FACE
10. Buzzer
If the air pressure drops below a pre-
set level, the Safety Guard is not
fitted, or there is an operational error,
then the buzzer will be operated.
11. D-Sub Input Socket
This socket is not required during
everyday use, and so it should be kept
covered at all times.
12. Circuit Protector
The electronic circuits are protected
by an overload device, and should a
fault occur, the trip will operate and
turn the machine off.
CAUTION !
Be sure to discover the cause of
the fault before turning the
machine back on.
Help should be sought from an
authorised person , and under no
circumstances should the Safety
Guard or Cover be removed by
unauthorised persons.
To re-set the machine, the button
should be pushed in after
approximately one minute.
13. Foot Switch Socket
This input socket is used when, for
reasons of wire size or terminal type, it
is not possible to use the Touch
Sensor.
14. Mains Input Socket
This socket is for the Input of the
240V, single phase power supply.
