V:\Mark\AP-F6 Operation Manual.doc
15
JST
AP-F6 PNEUMATIC CRIMPING MACHINE
Step 3.
Remove the M4 screw securing the
door on the left hand side of the main
Body Cover fabrication, and swing the
cover open against the hinges.
Step 4.
Loosen the lock-nut on the rear of the
belt pulley, and turn the bolt with the
aid of a spanner, either clock-wise or
counter-clockwise depending on which
direction the terminal needs to be
adjusted.
Repeat this adjustment until the correct
condition is obtained.
Note
Each complete revolution of the
adjuster moves the terminal
approximately 0.8mm in either
direction. Adjusting the bolt in a clock-
wise direction moves the terminal
towards the front of the press.
Step 5.
Close the access door, replace the cap
head screw, and reconnect the air and
electricity supplies.
6.2 Adjustment of the insulation
support
CAUTION !
Before removing the Safety Guard to
adjust the insulation support,
ensure that the air and electricity
supplies are disconnected.
Step1.
Set the Adjust Switch to the UP
position.
The ram rises to Top Dead Centre, and
the terminal is free to move relative to
the anvil.
