19
19
19
19
Failsafe
The failsafe/hold function is only available with PCM modulation. If you
have selected PPM modulation, the fail-safe screen will not appear.
Z-PCM modulation mode.
All channels can be HOLD or can take a pre-selected position. Three fail-safe
time delays are available. Select your chosen delay (0.2, 0.5 or 1.0 second) by
using the scroll bar to select the desired setting. For a pre-selected position
move the transmitter controls to the desired fail-safe position (throttle stick
low!) and store the settings by pressing the CLEAR key. A beep will sound to
confirm that the fail-safe positions have been stored.
S-PCM modulation mode.
All channels can be HOLD or individual channels can take a pre-selected
position. The fail-safe time delay is fixed at 0.5 seconds. Use the scroll bar to
select the desired setting as activate or inhibit. For each channel, move the
appropriate control to the desired fail-safe position and store the setting by
pressing the CLEAR key. A beep will sound to confirm that the fail-safe
positions have been stored.
Note:
To check that the settings have been stored successfully, switch the
transmitter off while leaving the receiver on. The servos should move to their
pre-set fail-safe positions.
We strongly recommend that you always select fail-safe for the throttle
channel and set the throttle position to low.
Note:
These preset positions remain stored in the transmitter’s model memory until data
reset has been performed. Therefore, you do not have to reset the fail-safe each time you fly.
Should you want to re-adjust the fail-safe presets, access the Fail-Safe Function and adjust
the presets as you have just done. The transmitter automatically stores the settings for the last
fail-safe adjustment.
