30
30
30
30
Assigning Channels
Using the scroll bar, move the cursor to the master channel. Press scroll bar
down to activate selection. Roll the scroll bar to select the desired channel.
Repeat this process to select the slave channel.
Origin Mixing
When origin mixing is activated any dual rate, exponential or other modifier
applied to the master channel is ignored on the slave channel. Therefore the
same dual rate, etc, modifiers are not present on the slave channel when a
command is inputted, they are only present on the master channel.
Operating with a Switch
Using the scroll bar, position the cursor on the SELECT function and
Press to select the desired switch for the particular program mix being used.
The default setting is for the mix to be permanently active (ON).
Activation by Throttle Stick Position
Click the scroll bar with THRO STK selected. Roll the scroll bar to select a
throttle stick activation position between 0% and 100% or to inhibit (INH).
Note that the stick resolution has 200 steps so that two clicks of the scroll bar
are required to change the percentage displayed.
Origin Mixing
When origin mixing is activated any dual rate, exponential or other modifier
applied to the master channel is ignored on the slave channel. Therefore the
same dual rate, etc, modifiers are not present on the slave channel when a
command is inputted, they are only present on the master channel.
Assigning Mix Values
Position the cursor on the desired “Point” and press. Increase or decrease the
mixing value using rolling action of the scroll bar or the CLR key. To activate
points 1,2,4 or 5 with “INH” displayed, press the scroll bar at that position to
display mixing value. Press the CLR key if you want to inhibit mixing.
Exponential Function
An exponential function allows you to "smooth" the selected curve. With the
cursor at the “point” position, use the scroll bar to select the EXP function
and press to activate exponential.
Standard Programmable Mixing (Mixers 3,4,5 and 6)
When activating the mix different mix values may be input for either switch
position (position 0 or position 1). Separate, different (if required) mix
percentages may be set for each side of neutral between 125% and –125%.
Assigning Channels
Using the scroll bar, move the cursor to the master channel. Press scroll bar
down to activate selection. Roll the scroll bar to select the desired channel.
Repeat this process to select the slave channel.
