18
18
18
18
points can be moved independently to any desired servo position from 0 to
100%.
Assigning Channels
Using the scroll bar, move the cursor to the master channel. Press scroll bar
down to activate selection. Roll the scroll bar to select the desired channel.
Operating with a Switch
Using the scroll bar, position the cursor on the SW SELECT function and
Press to select the desired switch for the particular program mix being used.
Assigning Mixing Values
Position the cursor on the desired “Point” and press. Increase or decrease the
mixing value using rolling action of the scroll bar or the CLR key. To activate
points 1,2,4 or 5 with “INH” displayed, press the scroll bar at that position to
display mixing value. Press the CLR key if you want to inhibit mixing.
Exponential Function
An exponential function allows you to "smooth" the selected curve. With the
cursor at the “point” position, use the scroll bar to select the EXP function
and press to activate exponential.
Standard Programmable Mixing (Mixer 3)
Determine the master and slave channels required for mixing. Using the scroll
bar, select PROG.Mix3. Using the scroll bar, position the cursor on to the
channels being mixed. Press the scroll bar down to select the desired channels
for mixing. To establish the mixing value, move and hold the master channel
control (up, down, left, or right) and set the slave servo mix value by pressing
and then rotating the scroll bar.
Establishing Offset (Mixer 3)
The purpose of the mixing offset is to redefine the neutral position of the
slave channel. Any desired position may be set for the offset reference point.
Select
offset
using the scroll bar, press down, then rotate the scroll bar to give
the required figure. The offset value (offset value from servo travel centre) is
now determined; however, the reference point mixing value is zero.