Jolly Mec FOGHEA, Инструкция по установке, использованию и обслуживанию

Страница: 37 / 48

37
2.4 Foghea air heating stove cladding assembly steps
• Foghea cladding assembly
The various parts must be assembled using the special screws provided. Make sure to follow the instructions listed below, after carrying
out the various connections.
Before assembly, open the glass door of the stove 6 , remove the support 7 undoing the 2 self-tapping screws located at the bottom,
remove the door (holding it open, lift it up and out) and the damper control knob 10 , as described in the relevant section of the assembly
card.
1 Fit the left column, placing it inside the door frame and tighten
the 2 inside self-tapping screws.
2 Fit the right column, placing it inside the door frame and
tighten the 2 inside self-tapping screws.
3 Fit the left support, to which the bottom tilting door is
already fixed
5
, to the left column with 2 M6 screws.
4 Fit the right stop of the bottom tilting door to the left column
with 2 M6 screws.
5 The bottom tilting door is now positioned.
6
Refit the glass door.
7 Fix the support above the glass door using the previously
removed self-tapping screws.
8 Fit the left and rear side, fixing the 4 M6 screws to the left
column in the inner counterfold.
9 Fit the right side, fixing the 4 M6 screws to the right column
in the inner counterfold, and secure the sides at the rear
with 2 M6 screws.
10
Insert the damper rod in the special hole on the right
side, inside the inspection door 11 , and refit the knob (as
described in the relevant section of the assembly card).
11
Connect and fix the electronic controller to the special
bracket on the inside of the inspection door.
12
With the clamps supplied, fix the two 22 cm long aluminium
sections to the special connections provided on the top of
the heating stove.
13 Fit the upper middle panel between the two columns, and
fix it with 4 M6 screws.
14 Place the top in the support provided, making sure
the aluminium pipes are fixed axially with the openings
provided for delivery of air in the room.
15
Place the pellet hopper lid in the support provided on the
top 14 .
16
Place the adjustable grilles in their supports provided on
the top 14 .
17
Fit the flue.
18 The Caldo Control and the burner fan must be connected
with Ø 80 mm pipes to the specially provided side collars,
fixing them with the clamps supplied.
The pipes must not
have any bends or be longer than 50 cm.
19 The exchange fan must be connected to the special
collar provided on the cladding (Ø 120 mm pipe); it is also
possible to remove the precut part in the left side (at the
bottom of the back), and extend the pipe up to a max.
length of 1.5 m.
1
3
4
2
5
6
7
8
17
18
9
10
15
16
12
11
13
14