Jolimark DP320, Руководство пользователя

Страница: 29 / 45

DP320 User's Manual
- 25 -
3.1.4 Labels
You must use the tractor as a pull tractor to print on labels. Keep these tips in mind:
1. Choose labels mounted on a continuous backing sheet with sprocket holes made for use with a
tractor. Do not print labels as single sheets, because the shiny backing sheet almost always slips
a little.
2. You load labels the same way you load continuous paper, except that the paper-thickness lever
should be set to 1, see page 2.5 for loading instructions.
3. Because labels are especially sensitive to temperature and humidity, use them only under normal
operating conditions.
4. Make sure the printing stays entirely within the printable area. (See the Appendix for
specifications.)
5. Do not leave labels loaded in the printer between jobs; they curl around the platen and may jam
when you resume printing.
6. Remove the labels from the printer, tear off the fresh supply at the rear of the printer; then press
LF/FF to advance the remaining labels out of the printer.
Caution: Never feed labels backward through the printer; they can easily peel off the backing
and jam the printer. If a label does become stuck in the printer, contact your dealer.
3.1.5 Envelopes
You can feed envelopes individually using the paper guide.
1. Before loading an envelope, set the paper-thickness lever to position 4 or 5. See page 2.5.
2. To load an envelope, follow the steps used to load single sheets in “Running the Self Test” on
page 1.8. Insert the wide edge of the envelope into the printer first, printable-side down. When
you insert the envelope between the paper guides, push it firmly and hold it until it feeds into the
printer.
Figure 3-17 Raise paper guide
Figure 3-18 Insert the envelop into the paper guide