Jolimark DP320, Руководство пользователя

Страница: 12 / 45

DP320 User's Manual
- 8 -
2. Check the label on the bottom of the printer to make sure the voltage required by the printer
matches that of your electrical outlet.
3. If the power cord is attached to the printer, connect it to the AC inlet on the printer.
4. Plug the power cord into a properly grounded electrical outlet.
Caution: 1. If the rated voltage and your outlet voltage do not match, contact your dealer
for assistance. Do not plug in the power cord.
2. Adopt the electrical outlet connecting the ground properly
.
1.8 Running the Self-test
The built-in self-test function demonstrates that the printer is working properly. You can run the
test with either continuous paper or single sheets; this section describes the easier way, with
single sheets.
Caution: You should use paper at least 210 mm (8.3 inches) wide to run the self-test;
otherwise, the print head prints directly on the platen.
1. Make sure the printer is turned off and the paper-select lever is pushed back to the
single-sheet position. Raise the paper guide upright.
2. While holding down the
TEAR
button, turn on the printer. Release the button after the
POWER
indicator flashes and the
ONLINE
indicator is off, which indicates the printer is out
of paper.
Power switch
Electrical outlet
Power cord
AC inlet
Figure1-18 Turn off the printer
Figure1-19 Set paper select lever