Johnson Controls tyco iSTAR Ultra, Руководство по установке и настройке

Страница: 22 / 118

Main Features
1–8 iSTAR Ultra Installation and Configuration Guide

Two relay Outputs

One AUX output (12 Vdc)*
* The AUX power and whichever reader power is used, are limited to a total of 1.5 Amp.
Aperio Hubs and Readers (per GCM RS-485 Comm Port)
An iSTAR Ultra GCM RS-485 Port supports a total of up to:

15 Aperio Hubs
• Hubs can be 1 Port or 8 Ports

16 Aperio Wireless Readers reporting to the Hubs
In other words, there can be up to 30 Hubs and/or 32 Wireless Readers per iSTAR Ultra.
There can be any combination of Hubs and Wireless Readers that do not exceed these limits.
The configured RM / Wiegand Readers can only exist to the extent that the configured Aperio
Readers are less than 32.
I/O (per ACM)

24 general purpose inputs.

16 general purpose relays:
• Dry or wet contact settable per relay by jumpers.
• 4-pin connectors to support NO/NC and Dry/Wet configurations.

Special purpose inputs:
• Tamper (from enclosure door).
• Main AC fail (from apS).
• Low external battery (from apS.)
• FAI Alarm State (J40 F input).
• FAI Relay Control State.
• FAI Interlock Key State (J40 K input).

Onboard battery low.

Large standard two-piece terminal blocks and spacing minimize the potential of mis-
wiring.
NOTE

The maximum number of enabled readers, wired or wireless, per
iSTAR Ultra is 32.

The maximum number of readers hard wired to ACMs is 16.
NOTE
The following 4 inputs to the host are determined by the firmware. There
is no actual wiring to the iSTAR Ultra board.