Johnson Controls tyco iSTAR Ultra, Руководство по установке и настройке, Страница: 114 / 118

Diagnostic Tests
8–4 iSTAR Ultra Installation and Configuration Guide
Diagnostic Tests
iSTAR Ultra firmware provides diagnostic information for:

Readers

Cards

Outputs

Inputs

Ethernet port
Use rotary switch SW3 on the GCM to activate diagnostic tests. Diagnostic information
displays on the iSTAR Ultra LCD.
Hardware Test
The onboard Ethernet tests display diagnostic information about both on-board Ethernet
connections, the USB ports, and the SD drive.
To Test the Ethernet port
1. Set switch SW3 to the position shown in Table 8-3.
2. Observe the LCD display for test results.
3. When the test is complete, set SW3 back to 0 or F to display status messages.
Table 8-2: LCD Status Display Messages
Rotary
Switch
SW3 Display General
Messages (Read only)
ICU Block On Display General Messages
(Read/Write/Update)
ICU Block Off
Set SW3 to: F 0
Use caution when activating outputs in a live system. For example, if the output opens the
shipping door, the shipping door will open when you test it.
NOTE 
Diagnostic tests add overhead to iSTAR Ultra processing, and may degrade system
performance. When the diagnostic tests are complete, deactivate the test by resetting SW3
to display status information.

Either 0 to display with full control, or F to display as read only.
Table 8-3: Ethernet Test Switch Settings
Switch Position Function
SW3 set to 8 Hardware Test (Onboard Ethernet 1 and 2, USB ports, SD
drive)