8
Joerns® Bed Frames
WeCare™ Bed
© 2022 Joerns Healthcare • 6110435 RevC • 22-2083
Baseboard Bumper
Recommended Tool: Rubber mallet
1.
Place the baseboard bumper as shown (Figure 14).
2.
Tap into place with a rubber mallet or press firmly
with the sole of your shoe until it locks into place
as shown (Figure 15).
Note:
If a longer baseboard bumper is needed for
use with Trendelenburg/Reverse Trendelenburg,
recommend ordering bumper 11011899AL.
Mattress Stops
Warning: Possible Injury.
Sitting on, or sliding over,
mattress side stop, can cause injury to the skin when
used with mattress that compresses to less than 1.5
inches under load.
Warning: Possible Injury.
Make sure mattress fills
the entire width between side stops. Failure to do so
could result in injury.
Tools Required: #2 Phillips screwdriver
1. Locate the screws at each corner of the inside
tube at the foot end of the screws mattress support
platform; one per side (Figure 16).
2.
Remove the screws using the #2 Phillips
screwdriver; do not discard the screws.
3. Position and insert the mattress stops in the
holes provided (Figure 17). Reinstall the screws
removed in step 2.
4. Locate the screws in the holes in each corner of
the inside tube at the head end of the mattress
support platform; one per side.
5.
Remove the screws using the #2 Phillips
screwdriver; do not discard the screws.
6. Position and insert the mattress stops in the holes
provided. Reinstall the screws removed in step 5.
IV Sockets
Joerns
®
WeCare™ Bed Platform has four IV sockets
as standard equipment. There are two sockets at head
end of bed and two at foot end (Figure 18). The IV
sockets are used with Joerns IV poles and most ½”
IV poles.
Figure 15
Figure 14
Figure 16
Figure 17
Figure 18
IV Socket
