5. OPERATION
5.1 GETTING STARTED
5.1.1 Handle assembly
(Fig. 3)
a). Place the tool on a flat, solid and clean surface.
b). Place the handle holder under the rubber
device on the tube.
c). Place the handle on the tube and align the
holes. Screw the handle to the support.
5.1.2 Shoulder strap assembly
(Fig. 4)
Insert shoulder strap clip on the hook.
Adjust shoulder strap to your desired length.
5.1.3 Mixing fuel
a). Use only fresh, clean unleaded gasoline with an octane rating of 90 or above.
b). Mix all fuel with 2-cycle engine oil at a ratio of 40:1.
CAUTION!
This engine is to be operated on a 40:1 mixture consisting of unleaded gasoline
and 2-cycle mixing oil only.
Some gasoline contains alcohol as oxygenate!
Oxygenated fuels may cause increased operating temperatures. Under certain
conditions, alcohol-based fuels may also reduce the lubricating qualities of some
mixing oils. Never use any fuel containing more than 10% alcohol by volume!
When an oxygenated fuel must be used, fuel containing an oxygenate such as
MTBE is to be preferred over an alcohol based fuel.
Generic oils and some outboard motor oils may not be intended for use in
high-performance air cooled 2-cycle engines, and should never be used in this
engine
Important!
Only mix enough fuel for your immediate needs! If fuel must be
stored longer than 30 days, it should first be treated with a stabilizer.
5.1.4 Filling the fuel Tank
a). Place the tank on a flat, level and clean surface.
b). Clear any dirt or other debris from around the fuel filler cap.
c). Remove the fuel cap, and fill the fuel tank with clean, fresh fuel mixture.
Fig.3
Fig.4
Fig.3
