SECTION 3 - CHASSIS & SCISSOR ARMS
3-30
– JLG Lift –
3121273
Spindle Disassembly
1. Place unit on bench with planet gears facing up.
2. Remove 3 output planet shafts.
NOTE:
These planet shafts are held in with a press fit. Use
the tapped hole in the end of the pin in conjunction
with a slide hammer or similar tool to remove them.
3. Remove the output planet gear, thrust washer, and
tanged washer out of each gear “window” of the
spindle.
NOTE:
The output planet gears are a very similar size to the
input planet gears, tag or label the planet gears to
avoid confusion.
4. Using a screwdriver remove the shaft bearing snap
ring.
5. Remove the shaft ball bearing from the center bore.
6. Press out the motor shaft seal from the center bore.
7. Remove the main bearing from the outside diameter
of the spindle.
NOTE:
This bearing is held in with a press fit. You will need
to pry against the spindle to remove it. The bearing
will need to be replaced when this is done.
8. Remove the motor o-ring from the groove on side
opposite from the carrier side.
Figure 3-31. Spindle Disassembly
1.
Spindle Sub-Assembly
2.
Shaft Ball Bearing
3.
Tanged Washer
4.
Thrust Washer
5.
Output Planet Gear
6.
Output Planet Pins
7.
Main Bearing
8.
O-Ring
9.
Shaft Seal
10.
Snap Ring
11.
Needle Roller Bearings
Содержание 1932RS
