jGun
JETYD Operations Manual
15
Loose fittings can be potentially dangerous when pressurized. Over
tightening fittings can cause permanent thread failure.
Loose fittings or over tightened fittings can cause personal injury and
tool damage.
Ensure that air line fittings are tight, but not overly tight.
Removing the Square Drive
You may remove the square drive for replacement or exchange between different drive types.
(Allen Drives, Clamp Drives, etc.) To remove the drive end:
1.
Disengage the continuous snap ring at the base of the square drive above the splined
section. The ring can be removed by prying the overlapping segment with a small flat-
head screwdriver.
Figure 12. Removing the jGun Square Drive Snap Ring
2.
Once the first section is out, continue prying small sections until the entire ring can be
removed.
3.
Once the retaining ring is removed, the square drive can be pulled out.
4.
If necessary, a screwdriver or other small bar can be placed through the hole in the square
drive for leverage when removing the drive.
