jGun
JETYD Operations Manual
17
Removing the Air Motor
To remove the air motor:
1.
Remove the small set screw from the directional lever on the back cover of the gun.
2.
Pull the lever off of the gun,
3.
Remove the four Allen screws on the back cover of the gun.
4.
Next remove the back cover and the gasket underneath.
5.
Pull the motor straight back; it is not pressed in. It may come apart, but be careful not to
lose the guide pin.
6.
Assemble in the reverse order of disassembly.
Calibration
JETYD provides a pressure / torque conversion chart with every tool. The stated accuracy is +/-
5%. If you properly maintained your tool and keep it in good working condition, it will stay
within this stated accuracy. Proper maintenance procedures can be found in this JETYD
Operations Manual.
If the torque required is for a critical application or if the torque output is in question, the torque
accuracy or output of a tool can and should be verified through calibration. Calibration is
available by JETYD Corporation for a minimal fee.
