FRL
28
JETYD Operations Manual
FRL maintenance and repair must be performed by a qualified pneumatic
technician.
Modifying an FRL or FRL accessory is dangerous and invalidates the warranty.
Inspect the unit before each use. Replace any obviously worn or damaged parts.
When not in use, properly store the FRL, hoses and couplers.
Personal Protective Equipment
Always wear the appropriate personal protective equipment when operating the
FRL and jGun including gloves, safety goggles, hearing protection, hard hat, and
safety shoes
Air Supply Requirements
Air supply line must be ½-inch minimum diameter to allow adequate air flow to
the jGun
Air supply must be 90 psi @ 30 cfm minimum.
Ensure that air line fittings are tight and leak free. Do not over tighten air line
fittings.
Always use the FRL Unit provided with the jGun. Never use a substitute oiler and
regulator with a jGun.
Set the air pressure while the tool is running as described in the
Setup
and Use
section.
Open the air supply connected to the FRL unit and run the torque wrench
while setting the pressure on the gauge.
Set the air pressure to the PSI needed to achieve desired torque shown on the
provided pressure/torque conversion chart.
