Jetmaster INSET STOVE MKIII 60i, Руководство пользователя

Страница: 19 / 22

Installation & Operation manual of Jetmaster UK clean burn range
Page 19
Revision 10/02/2010
Operating Instructions
Lighting after Installation
A Jetmaster should not be run hard until all cement and plasterwork is completely dry and cured. As a basic guide
the installer should
a. Allow a 7-day drying time if the house has other forms of heating.
b. Allow at least 14 days if the installation is in a new or unoccupied property, or is fitted into a completely
new chimney breast.
Operating Tool
The operating tool serves two functions
It is used to open the door and to operate the air control lever
Door Operation
To open the door, insert the operating control into the door latch on the right hand side of the door. Turn the
operating tool anti clockwise to open and clockwise to close
Wood Burning and Basket Grates
Jetmaster fires may be used to burn a variety of fuels. If burning wood then no additional accessories are required
as wood can be burnt on the cast gate and V boards. However, if burning smokeless fuel then basket grates are
available to ensure that the fuel is burned in the most effective way. Make sure that you have the right accessories
to get the best out of your fuel and your fire.
Wood Burning
If burning wood then it should be burnt on the cast grate and V boards. (Coal or smokeless fuel cannot be burned
in this way).
Allow the ash to build up to about 1” (25mm) deep in the base to ensure even and efficient burning.
Ash Removal After several burns as the ash builds then it can be raked through the cast grate so as to fall in the
ash pan below. This can be emptied by sliding out. If ash builds at the sides and cannot be removed through the
cast grate then it is desirable to clean out a few shovels full of the surplus ash as required. (This will be more
frequent if burning heavily).
When removing the ash pan and replacing always ensure that it is fitted the correct way around. The ash pan
should be fitted with the handle facing to the front.
Lighting with Wood